Discover more like JDM Honda 4G Prelude Parking Sensor Corner Sensor Switch BB1 BB4 92-96

OEM factory optional Honda Access rear corner sensor wiring harness with control unit, as removed from a BB1 chassis Honda Prelude, years 1992 - 1996. This rear loom set mounts in the boot or trunk of the vehicle, it has piggy back plugs which connect to one tail light plug on the vehicle, this is t...

OEM factory optional Honda Access front parking sensor or corner sensor control unit relay, as removed from a CD chassis Honda Accord, years 1994 - 1997. This will also fit: - CE Honda Accord 1994 - 1997 - BB1 BB4 Honda Prelude 1992 - 1996 - May also suit other Honda vehicles if the wiring plugs and...

OEM factory optional Honda Access bulk lot of rear parking sensors or corner sensors and wiring looms, as removed from an RA chassis Honda Odyssey, years 1994 - 1999. Sensor part numbers: 39692-SX0-030, 39680-SX0-0030, 39685-SX0-0030 Wiring Loom part numbers: 32113-SX0-001 and 32112-SX0-002 Conditio...

OEM factory optional Honda Access rear corner sensor wiring harness with control unit, as removed from a CD chassis Honda Accord Sedan, years 1994 - 1997. This rear loom set mounts in the boot or trunk of the vehicle, it has piggy back plugs which connect to one tail light plug on the vehicle, this ...

Aftermarket new ignition switch unit to suit Honda Civic and Honda CRX, years 1984 - 1987. This will also suit: Honda Integra 1985 - 1989 Honda Ballade 1983 - 1986 For warranty terms and conditions please see the Warranty Info For all other information including delivery and handling times please see the FAQs or at the details below

OEM factory genuine Stanley (made in Japan) left and right amber side marker pair as removed from an EF chassis Honda Civic, years 1988 - 1991. These will also suit the below vehicles; - EF Honda CRX 1988 - 1991 - EF Honda Civic Shuttle or Wagovan 1988 - 1991 - BA Honda Prelude 1988 - 1991 Condition...

Please confirm suitability for your engine before ordering Suits: Honda Accord - 2.3L VTEC (F23A) - 1998-2002 Honda Civic - 1.7L - 2002-03 Honda Odyssey - 2.3L (F23A) - 1998-2003 Honda Prelude - 2.2L VTEC (H22A) - 1997-2001 Honda Torneo - 2.2L (H22A) - 2000-02 Replaces Green Cap Sensor ONLY Replaces: Honda - 30530-P5M-003, 30530-P5M-013, 30530-PM5-013

Type Strut Brace, Vendor Non-Branded, This is a aftermarket rear strut brace to fit Honda Prelude 1997 to 2001 BB5-9 models.Has an extra hole drilled on left end, and edge has been ground down.Please see our ABOUT page for terms and conditions of sale.If you are not sure this part will fit your Honda please.

Type Air Intake, Vendor Apexi, This is a genuine Apexi pod filter attached to a short steel pipe.This will plug into the factory air intake hose of Honda Accord 1994 to 1997 CD models, Honda Prelude 1992 to 1996 BA8 9 BB1-4 models, and Honda Odyssey 1995 to 1999 RA1-5 models.Please see our ABOUT page for.

- 2 Inch LCD Display, Audio Alert, 0.3 To 2.5M Detecting Distance At a Glance. - Intelligent smart parking system with 8 ultrasonic sensors - Front and rear sensor with visual and audio aids to make parking easy - LCD display shows where any hidden obstacles are so you can reverse with ease - Quick ...

Type Strut Brace, Vendor Non-Branded, This is a front strut brace with mild corrosion.Will fit a Honda Prelude 1997 to 2000 BB5-8 modelsHas blue ends.2 in both in similar condition.Please see our ABOUT page for terms and conditions of sale.If you are not sure this part will fit your Honda us and.

Type Spoiler, Vendor Non-Branded, This is a spoiler to fit Honda Prelude 92-96 models.Has a previously repaired crack on the rear, a paint job, and what sounds like a stone on the inside.Please see ABOUT page for terms and conditions of sale.

SPECIAL OFFER Add 1 of our JDM themed caps to to each JDM Honda Integra tee purchased and get 25% off the cap.. Quality AS Colour Black Staple tee with JDM Honda Integra screen printed design front and back. - Regular fit - Crew neck - Mid weight, 180 GSM, 28-singles - 100% combed cotton - Neck ribbing, side seamed, shoulder to shoulder tape, double needle hems, preshrunk to minimise shrinkage.

The BLOX Racing EGR block-off plate allows the EGR valve to be disconnected or removed entirely. The block-off plate helps clean up your engine bay or for when additional clearance is needed in certain custom swaps. EGR's are mostly found on JDM and US 90 Accord F-series engines (F20/22/23) as well as all 92-01 Prelude H-series engines.

JDM factory red hazard switch, as removed from a right hand drive (RHD) Japanese Honda CR-V years 1997 - 2001. Condition: Good used condition as pictured. Items are usually sent within 24 hours of payment, we are located in New Zealand. Courier within is usually 1-2 days depending on your location. ...

Suits front and rear EFS bars where fitting with parking sensors is required. 4 per pack. Fitment Notes Sensor holes in bars normally require step drilling to 27mm to accept these sensor holders.

Brand new aftermarket product. In good quality. Made of steel. 50mm socket. 1/2" square drive. Suitable for use with: Honda Accord 2.2L 4Cyl 1990-1997 Honda Accord 2.7 L 6Cyl 1996 Honda Accord 2.3 L 4Cyl 1998-2002 Honda Accord 2.4 L 4Cyl 2003-2016 Honda Accord 3.0 L V6 1998-2016 Honda Civic 1.6 L 4C...

OEM / JDM factory Stanley clear corner light set, as removed from an EF chassis Civic Hatchback years 1990 - 1991. Please NOTE: These lights are for the 1990 and 1991 model Japanese face-lift conversion only and will NOT suit any stock US-spec front end. Condition: Good condition as pictured. There ...

Where is my car Test your parking skills with the 60 challenges featured in SmartGames Puzzles Parking Puzzler. Parking Puzzler is a unique deduction game where players must find the right spot for each car as indicated using the clues provided in the challenges. No illegal parking is permitted Cars...

This listing is for your own custom Parking Only sign, printed with the wording of your choice onto 3mm thick acrylic plastic. Suitable for indoor or outdoor use. Size: A4 (210x297mm) Select your text colour by using the dropdown menu, and include the text that you would like above the arrow. E.g. S...

Replaces part number 90017-PY3-003 (16X49) If your looking to pull a part your bottom end or replacing the crank/ or pulley or maybe the original bolt you had is stuffed or you lost it then your bound to need to replace this a must need when your refreshing your engine OEM is Best

- 1/4 Inch Color CMOS, IP67 Camera, 5 Inch Display, Nigh Vision, 120 Degree Lens Key Features. - A large 5 inch screen provides easy viewing with adjustable base - See blind spots with ease thanks to a wide angle 120 degree lens - An IP67 waterproof rating ensures the cameras protected from the elem...