Orton Vent Master

The Vent Master works by creating a small downdraft within the kiln, the chamber is kept at a slight negative pressure. Gases and Fumes are pulled out of the kiln through a small hole and mixed with fresh room air then exhausted to the outside atmosphere through a 100mm duct (this length of duct is supplied by customer).

The system gives the following benefits • Fume removal improves firings • Extends life of elements by removing moisture • Can aid in cooling of the kiln if desired • Improves temperature uniformity in the chamber • Helps to remove poisonous & corrosive fumes • The unit can usually sit within the footprint of the kiln.

Expansion Kits are also available to enable two kilns to run off a single Vent Master motor.

Watch Vent Master installation tutorial here.

See Vent Master FAQ here.