Dragon 1/35 StuG.III Ausf.G Initial Production Plastic Model Kit

The Type III assault gun, which utilized the body of the Type III tank and mounted the main gun in a fixed fighting compartment, was easy to produce and could be equipped with a larger gun, so about 10,000 of each type were produced by the end of the war.

The final and most widely produced type was the "G" type.

Production began in December 1942 and continued until the end of the war, with minor modifications.

The main gun was the StuK40, a 48-caliber 7.5cm assault cannon.

Nearly 8,000 vehicles were produced, and amid the shortage of tanks, it was assigned to tank units and continued to play an active role on the frontlines until the end of the war.

The G-type also differed in various ways depending on the time of production, with the early production type adopting a welded main gun shield and other characteristics.

About the model:

The model is a 1/35 scale reproduction of the German III assault gun of World War II.

This plastic model assembly kit is a model of the very early production type of the final production type G.

The low fighting compartment equipped with the long-barreled 7.5cm gun is modeled with characteristically characteristic shape using a slide mold.

In addition, parts of the engine deck at the rear of the vehicle body are also reproduced with parts using slide molds.

Inside the fighting compartment, the breech of the 7.5cm main gun, recoil guard, recoil cylinder, and other base parts are also reproduced in detail.

In addition, interior parts such as communication equipment and floor panels inside the fighting compartment are also modeled for a mechanical finish.

The lower part of the vehicle body is also an integral part using a slide mold.

The torsion bar suspension is also modeled separately.

The crawler tracks are made of assembled magic tracks.

The footwear is made of assembled Magic Tracks to tighten up the finish.

Reproduce the very early production type of Type III assault gun G in 1/35 scale.

Adopt the Magic Tracks assembled realistic finish to the crawler

Reproduce the shape of the battle chamber in detail, down to the details of the bolts.

Interior that has been reproduced to the base of the gun barrel and floor panels