LR3 Pinch Detector Terminals

Replacement anti-pinch pins for Litter-Robot III Open Air

Installation

Note it is recommended that pinch detector terminals be purchased if an upgrade kit or replacement DFI kit is purchased, as pinch detectors are subject to corrosion and debris, due to location in the waste drawer cavity.

DFI kit includes pinch detectors.

NOTE touch points (heads) can be cleaned by pressing on the cover (DO NOT PULL as fragile by design and not covered by warranty if broken) to open the gap between heads. Wipe with a dry earbud or Qtip. If more cleaning is needed, a very light sand with fine sandpaper, emery board or similar to remove any corrosion or dirt, so there is good contact for power flow can be done, but replacement will be needed if sanded/abraded as the silver coating does need to be intact to prevent oxidation. Photos for review can be submitted at support@catevolution.co.nz