DAB JET Water Pump - nXt Pro

All Pumps Have 25mm Female Inlet and 25mm Male Outlet Pump Information:

- Pumps Should be Protected from the elements, Big Water Tanks offers a tidy pump house for this purpose, ventilation and drainage is very important
- Incoming suction pipework must be a minimum 25mm Internal diameter and Ideally have some flexibility especially on the tank end of the pipework to allow for expansion and contraction of the tank. Suction Pipe Length over 5m in length should be increased to 32mm and over 10m should be 40mm. It should also not allow for any air pockets by going up and down.
- Suction Lift Pipework should have a non return valve if over 1m of lift, and should be increased to 32mm diameter is over 3m of suction lift and 40mm diameter if suction lift is over 6m with an absolute max suction lift of 9m
- Pressure Tank is not required if in standard use as we only sell the NXTP version of the controller with a small 0.3l Pressure tank attached however adding a pressure tank will always increase the life of the pump, if using the controller on MODE 2 (setting a cut in and cut out pressure) then a larger pressure tank is required.
- Priming your pump requires opening the priming port and pouring water in to allow the pump to pump something, this may have to be repeated in suction lifts where the tank has run dry.
- 2 Year Return to Base Warranty on all DAB pumps Downloads

- DAB JETCOM Data Sheet
- DAB JINOX Data Sheet
- DAB Jet Pump Operations Manual
- NXTP Controller Data Sheet